Reassembly

REASSEMBLY

Front Driveshaft (TJ-BJ Type)
1. Wrap tape around the drive shaft splines (TJ side) to prevent damage to the boots.
2. Apply grease to the joint(BJ) boot on the side of wheel and install the boots.

Recommended lubricant :
B.J. Boot grease : CENTOPLEX 278M/136K
T.J. Boot grease : MX-13KT


3. Install the bands to both boots.




4. Using clamp, secure the boot bands.

Clearance(A) :2.0 mm (0.079 in.) or less





5. To install the dynamic damper, keep the BJ shaft in a straight line and secure the dynamic damper with the dynamic damper bands.
6. Install the TJ boot bands and TJ boot.
7. Using the alignment marks(D) made during disassembly as a guide, install the spider assembly(A) and snap ring(B) on the driveshaft splines(C).








8. Add the specified grease to the joint(TJ) boot as mush as wiped away at inspection.
9. Install the boots.
10. To control the air in the TJ boot, keep the specified distance between the boot bands when they are tightened.
Standard value (A/B)











Front Driveshaft (SFJ-BJ Type)

1. Wrap a tape around the driveshaft spline(SFJ side) to avoid boot damage.




2. Apply specified grease at the driveshaft and install the boot.





3. Add the specified grease in the amount wiped away at the of inspection.
4. Tighten the boot band.

CAUTION:
Adjust the distance between boot bands within the specification range when tightening the boot band to adjust air in the boot.